TT Quattro Coupe V6-3.2L (BHE) (2005)
-
Remove nut from tie rod ball joint.
Note: Leave nut screwed several turns onto tie rod ball joint to protect thread.
-
Remove tie rod from steering arm with puller Kukko129/0.
-
Disconnect connector from ABS wheel speed sensor.
-
Press out drive axle.
Note: Make sure there is sufficient clearance when pressing out drive axle.
-
Remove drive axle from wheel bearing housing and tie up.
-
Remove bolt and nut securing wheel bearing housing/suspension strut.
Note correct position of bolt - 1 - when installing (install from back to front in direction of travel).