TT Quattro Coupe V6-3.2L (BHE) (2005)
Vehicle Speed Sensor: Testing and Inspection
Speed Signal, Checking
Speed Signal, Checking
The following procedure requires a test drive. Observe all safety precautions.
Special tools, testers and auxiliary items required
-
Multimeter.
-
Wiring diagram.
Test requirements
-
The Speedometer G21 OK.
-
The Motronic Engine Control Module (ECM) J220 fuses OK.
-
Battery voltage at least 12.5 volts.
-
All electrical consumers such as, lights and rear window defroster, switched off.
-
A/C switched off.
-
Ground (GND) connections between engine/transmission/chassis OK.
-
Ignition switched off.
Test procedure
-
Perform a preliminary check to verify the customers complaint. See: Testing and Inspection/Scan Tool Testing and Procedures/General Diagnosis
Start diagnosis
-
Connect the scan tool.
-
Perform a road test with a vehicle speed greater than 5 Km/h.
-
Using the scan tool, Check the vehicle speed:
Diagnostic text
Specified value
Vehicle Speed
Approx. Vehicle Speed
-
Compare the vehicle speed on the scan tool to the Speedometer G21.
Specified value: a difference of no greater than 10%.
If the specified value was not obtained or no speed was displayed:
-
Check the wiring from the Motronic Engine Control Module (ECM) J220 to the Instrument Cluster Control Module J285 for an open circuit, Short
to Battery (+), or to Ground (GND).
-
Check the wiring connection for damage, corrosion, loose or broken terminals.
-
If necessary, repair the faulty wiring connection.
Final procedures
After repair work, the following work steps must be performed in the following sequence:
1. Check the DTC memory. See: Testing and Inspection/Scan Tool Testing and Procedures/Diagnostic Mode 03 - Read DTC Memory
2. If necessary, erase the DTC memory. See: Testing and Inspection/Scan Tool Testing and Procedures/Diagnostic Mode 04 - Erase DTC Memory
3. If the DTC memory was erased, generate readiness code.
End of diagnosis.