TT Quattro Coupe V6-3.2L (BHE) (2005)
/Page-1013003.png)
-
Assembly is performed in the reverse of the removal.
Final procedures
After repair work, the following work steps must be performed in the mentioned sequence:
1. Check the DTC memory. See: Computers and Control Systems/Testing and Inspection/Scan Tool Testing and Procedures/Diagnostic Mode 03 -
Read DTC Memory
2. If necessary, erase the DTC memory. See: Computers and Control Systems/Testing and Inspection/Scan Tool Testing and Procedures/Diagnostic
Mode 04 - Erase DTC Memory
3. If the DTC memory was erased, generate readiness code.
End of diagnosis
