TT Quattro Coupe V6-3.2L (BHE) (2005)
-
Unscrew bolt - B -.
-
Remove sensors - A - from transmission together with wire.
Installing
Installation is performed in reverse sequence. Note the following:
-
Lubricate sensors - A - with gear oil and insert into opening on side of transmission.
-
Tighten new bolt (M6) - B - to 10 Nm.
-
Install mechatronic - C -.
Note: When installing the Direct Shift Gearbox (DSG) Mechatronic -J743-, the wire for connector - A - must not become trapped or pinched. If the
wire is damaged, the Sensor for transmission RPM / Transmission fluid temperature sensor -G93- / -G182- will have to be replaced.
-
Secure wire to retainers - arrows -.
-
Plug in connector - A -.
-
Install oil pan.
-
Connect battery.
-
Follow steps required after connecting battery.
-
Fill with gear oil.
-
Perform basic setting using vehicle diagnostic, testing and information system VAS 5051.