TT Quattro Coupe V6-3.2L (BHE) (2005)
/Page-193004.png)
-
Clip in speed sensor wiring (arrows).
Note: Make sure sensor wire is not twisted in wheel housing.
-
Cut 2-pin connector off new speed sensor wiring with wire stripper pliers.
-
Strip 15 mm of insulation from end of wire with wire strippers and bend back half.
-
Connect speed sensor wiring with aid of suitable crimp connector from wiring harness repair kit VAS 1978.
Note:
The instructions supplied with wiring repair kit VAS 1978 normally do not permit repairs to the wiring of the ABS system. However, this only
applies to the screened wiring in the system.
