TT Quattro Coupe V6-3.2L (BHE) (2005)
/Page-1685001.png)
Starter Motor: Service and Repair
Starter - 6-Cylinder Engine, Removing And Installing
CAUTION:
Before beginning repairs on the electrical system:
-
Obtain the anti-theft radio security code.
-
Switch off all electrical consumers.
-
Switch ignition off and remove ignition key.
-
Disconnect negative ( - ) battery terminal.
-
When disconnecting and reconnecting battery terminals, observe all applicable Notes and torque specifications, as well as instructions on
performing OBD program and electrical system function checks as specified.
Special tools, testers and auxiliary items needed
-
VAG 1331 Torque wrench (or equivalent 5 - 50 Nm )
Removing
-
Disconnect battery.
WARNING:
-
The cooling system is under pressure when the engine is warm. If necessary reduce pressure before repair.
-
Cover cap of expansion tank with rag and open carefully, as hot steam i.e. hot coolant may escape when opening.
-
Slowly remove cap from coolant expansion tank.
When removing engine compartment trim cover clips, note the following:
-
To remove clips -1- at lock carrier, press pin -2- approx. 4 mm only (do not press right through). Then remove clip.
