TT Quattro Coupe V6-3.2L (BHE) (2005)
Steering Angle Sensor: Removal and Replacement
Return spring with slip ring and steering angle sensor G85, removing and installing
Driver-side airbag and steering wheel removed.
-
Pull steering column all the way out and down.
-
Remove bolts - 1 - (2x). Tightening torque: 2.8 Nm
-
Remove handle - 2 -.
-
Remove two phillips-head screws - arrows -.
-
Tightening torque: 0.6 Nm.
-
Remove upper trim on steering column switch - 1 -.
To install, insert upper section into the retainers on lower section, swing down and secure with screws.
-
Remove screws - 2 - (2x). Tightening torque: 0.6 Nm
-
Remove hex bolt - 1 -.
-
Tightening torque: 0.6 Nm.
-
Remove lower trim on steering column switch - 3 -.