TT Quattro Coupe V6-3.2L (BHE) (2005)
-
Remove coupling rod from suspension strut on both sides of the vehicle.
-
Pull spring clip out from bracket and detach brake hose.
-
Detach wire for speed sensor from suspension strut.
-
Remove noise insulation panel.
-
Unbolt drive axle from flange shaft on transmission.
Initial tightening torque: 10 Nm
Tightening torque: 70 Nm
-
Secure drive axle with wire.
-
Remove bolt and nut securing wheel bearing housing/suspension strut.
Note installation position of bolt. (See illustration).
-
Insert special tool 3424 into slot - arrow -.
-
Turn ratchet 90° and remove from 3424.
-
Press brake disc toward suspension strut by hand.
Otherwise the strut tube can become misaligned in the bore of the wheel bearing housing.
-
Pull wheel bearing housing downward from strut tube.