TT Quattro Coupe V6-3.2L (BHE) (2005)
Wheel Bearing: Removal and Replacement
Component, Assembly Overview
Component, assembly overview
1 -
Suspension strut
^
The same version must be installed on both sides
^
Remove suspension strut from wheel bearing housing
2 -
Hex bolt
^
Always replace if removed
3 -
Hex socket head bolt, 8 Nm
4 -
ABS wheel speed sensor
^
Before inserting sensor, clean inner surface of installation hole and coat with lubricating paste G 000 650.
5 -
Self-locking nut
^
Tightening torque: 45 Nm
^
TT VR6 Roadster: 75 Nm
^
Always replace if removed
6 -
Tie rod ball joint
7 -
Hex bolt, 10 Nm
8 -
Self-locking 12-point nut
Pay attention to notes and table
^
Always replace if removed
9 -
Phillips-head screw, 4 Nm
10 -
Brake disc (ventilated)