TT Quattro Coupe V6-3.2L (BHE) (2005)
-
Unbolt heat shield for axle shaft (right side) from bevel box.
-
Place drip tray V.A.G1306 under transmission.
-
Remove bolt for flange shaft (right side) - arrow 1 - using hex key T10107. (Bolt must be replaced).
-
Remove flange shaft using puller T10037.
-
Pry out flange shaft oil seal using assembly lever.
Installing
Perform installation in reverse sequence of removal. Note the following:
-
Drive in new oil seal as far as stop using thrust piece T10049.
-
Fill space between sealing lip and dust lip half-full with grease G52 128 A1.
-
Carefully drive in flange shaft (while turning).
-
Secure flange shaft using new countersunk bolt.
-
Install right axle shaft.
-
Install guard plate for axle shaft onto bevel box.
Checking oil level in bevel box.
Tightening torques