TT Quattro Coupe V6-3.2L (BHE) (2005)
-
Put wheel hub - 1 - and hollow piston cylinder - 2 - with pull rod on wheel bearing.
-
Fit special nut - 4 - and thrust piece - 3 - (with collar facing special nut) on inboard side of wheel bearing housing.
-
Press in wheel hub by actuating pump.
1 -
Wheel hub
2 -
Hollow piston cylinder HKZ-15
3 -
Thrust piece E-5
4 -
Special nut E-8-214 and pull rod
Pay attention to the following points on installation:
-
Clean inner splines of wheel hub.
-
Screw on new 12-point nut as far as possible.
-
Secure brake caliper to wheel bearing housing.
-
Attach coupling rod to suspension strut with new nut.
-
Lower vehicle, but make sure that wheels do not yet touch ground.
Otherwise the wheel bearing could be subject to excessive load and damaged.
-
Have a second technician press the brake pedal.
-
Tighten 12-point nut.