TT Quattro Coupe V6-3.2L (CBRA) (2008)
Rear Subframe Mount: Service and Repair
Subframe mount, removing and installing
Special tools, testers and auxiliary items required
^
Hollow piston cylinder VAS 6179
^
Hydraulic cylinder VAS 6178
^
Engine/transmission jack V.A.G 1383 A with universal transmission support V.A.G 1359/2
^
Assembly tool T10263
^
Assembly tool T10205/13
Front or rear bonded rubber bushings, removing
-
Remove rear wheels.
-
Remove coil springs.
-
Remove exhaust system rear muffler.
-
Disconnect electrical lines to Haldex clutch and, on vehicles with level control sensor, connectors.
-
Remove stabilizer bar.
-
Remove tie rods.
-
Unclip electrical lines to upper transverse links.
CAUTION: Before -LOOSENING- subframe bolts, secure vehicle against tipping over (e.g. load luggage compartment with approx. 50 kg).