TT Quattro Coupe V6-3.2L (CBRA) (2008)
/Page-2620003.png)
-
Carefully pull instrument panel down from central tube.
‹› 2 technicians are needed to remove the instrument panel.
-
Remove instrument panel from the vehicle interior.
-
Lay instrument panel on a soft surface.
Installation
Installation is reverse of removal, but note the following:
CAUTION!
Note assignment of airbag unit to instrument panel.
-
Position instrument panel and guide electrical connectors for Sunlight Photo Sensor (G107), Central Locking -SAFE- Indicator Lamp (K133) and
speaker through openings in instrument panel.
-
Check whether a rubber buffer - 2 - is present at left and right on clamp - 1 - on lower windshield frame.
-
Check whether there is a plastic cap - 4 - on centering bracket - 3 - on central tube.
-
When sliding instrument panel on, ensure clips engage in box-shaped profiles on bottom side of instrument panel.
-
Align instrument panel and tighten screws.
CAUTION!
Ignition must be on when connecting battery. If pyrotechnic components (e.g. airbag, belt tensioner) are not repaired correctly, they may
deploy unintentionally after connecting battery. There must not be anyone inside the vehicle when connecting the battery.
