TT Quattro Coupe V6-3.2L (CBRA) (2008)
Procedure for both sides of vehicle
-
Remove side instrument panel cover. Refer to => [ Instrument Panel Side Cover ] See: Dashboard / Instrument Panel/Service and
Repair/Instrument Panel.
-
Remove sill panel strip - 3 - from door sill in transition area to lower A-pillar trim. Refer to => [ Sill Panel Trim ].
-
Unclip lower A-pillar trim - 2 - with Trim Removal Wedge (3409).
Installation
To install, perform the steps used in removal in reverse order. Observe the following when doing so:
‹› If trim clamps remain in body mounting points, remove these and insert them in trim.
‹› Check clamps for damage or deformation, replace if necessary.
-
Clip in lower A-pillar trim - 2 - and stretch lip of door seal - 4 - over upper A-pillar trim - 1 - and sill panel strip - 3 -.