TT Quattro Coupe V6-3.2L (CBRA) (2008)
If the manufacturers test box is being used. Perform the following step.
-
Install the Test Box 105 Pin (VAG1598/31). See: Engine Control Module/Testing and Inspection/Engine Control Module
If the manufacturers test box is not being used. Perform the following step.
-
Remove the Engine Control Module (ECM) (J623). Refer to => [ Engine Control Module, Replacing ] See: Engine Control Module/Testing and
Inspection/Engine Control Module.
-
Using a Multimeter, check the Data Bus On Board Diagnostic Interface (J533) electrical harness connector to the Engine Control Module (ECM)
(J623) electrical harness connector T81 for resistance.
Specified value: 1.5 ohms Max.
If the specified value was not obtained:
-
Check the wiring connection for an open circuit, short circuit to Battery (+) or Ground (GND).
-
Check the wiring connection for damage, corrosion, loose or broken terminals.
-
If necessary, repair the faulty wiring connection.
If no malfunction is found in the wiring:
-
Replace the Data Bus On Board Diagnostic Interface (J533).
Final procedures
After repair work, the following work steps must be performed in the following sequence:
1. Check the DTC memory. Refer to => [ Diagnostic Mode 03 - Read DTC Memory ] See: Testing and Inspection/Scan Tool Testing and
Procedures/Diagnostic Mode 03 - Read DTC Memory.
2. If necessary, erase the DTC memory. Refer to => [ Diagnostic Mode 04 - Erase DTC Memory ] See: Testing and Inspection/Scan Tool Testing
and Procedures/Diagnostic Mode 04 - Erase DTC Memory.
3. If the DTC memory was erased, generate readiness code. Refer to => [ Readiness Code ] See: Testing and Inspection/Monitors, Trips, Drive
Cycles and Readiness Codes.
End of diagnosis.