TT Quattro Coupe V6-3.2L (CBRA) (2008)
/Page-971002.png)
If any of the specifications are not obtained:
-
Replace the Leak Detection Pump (LDP) (-V144- ).
If the specified values are obtained:
Checking voltage supply
‹› The voltage for the Leak Detection Pump (LDP) (-V144- ) is supplied by the Motronic Engine Control Module (ECM) Power Supply Relay (J271)
OK.
-
Using a Multimeter, check the Leak Detection Pump (LDP) (-V144-) electrical harness connector terminal 3 for voltage.
-
Operate the starter briefly.
Specified value: battery voltage.
-
Switch the ignition off.
If the specified value was not obtained:
