TT Quattro Coupe V6-3.2L (CBRA) (2008)
-
Check the electrical harness connector for damage, corrosion, loose or broken terminals.
-
If necessary, repair the wiring connection.
If no malfunctions are found in the wiring:
Checking Ground (GND)
-
Using a Multimeter, check the Fuel Pump (FP) 2 Relay (J49) socket 4/85 to the Engine Control Module (ECM) (J623) electrical harness connector
T81 terminal 65 for resistance.
Specified value: 1.5 ohms.
If the specified value was not obtained:
-
Check the Fuel Pump (FP) 2 Relay (J49) socket 4/85 to the Engine Control Module (ECM) (J623) electrical harness connector T81 terminal 65 for
an open circuit or a short to Battery (+).
-
Check the electrical harness connector for damage, corrosion, loose or broken terminals.
-
If necessary, repair the wiring connection.
If no malfunctions are found in the wiring and the voltage supply was OK:
-
Replace the Fuel Pump (FP) 2 Relay (J49).
-
Perform a road test to verify repair.
If the fault does not return:
Repair complete, Generate readiness code. Refer to => [ Readiness Code ] See: Computers and Control Systems/Testing and Inspection/Monitors,
Trips, Drive Cycles and Readiness Codes.
-
End diagnosis.
If the fault does return and no malfunction is detected in the wiring and the voltage supply was OK:
-
Replace the Engine Control Module (ECM) (J623 ). Refer to => [ Engine Control Module, Replacing ] See: Computers and Control
Systems/Engine Control Module/Testing and Inspection/Engine Control Module.
-
Assembly is performed in the reverse of the removal.
Final procedures
After the repair work, the following work steps must be performed in the following sequence:
1. Check the DTC memory. Refer to => [ Diagnostic Mode 03 - Read DTC Memory ] See: Computers and Control Systems/Testing and
Inspection/Scan Tool Testing and Procedures/Diagnostic Mode 03 - Read DTC Memory.
2. If necessary, erase the DTC memory. Refer to => [ Diagnostic Mode 04 - Erase DTC Memory ] See: Computers and Control Systems/Testing and
Inspection/Scan Tool Testing and Procedures/Diagnostic Mode 04 - Erase DTC Memory.
3. If the DTC memory was erased, generate readiness code. Refer to => [ Readiness Code ] See: Computers and Control Systems/Testing and
Inspection/Monitors, Trips, Drive Cycles and Readiness Codes.
End diagnosis.