TT Quattro Coupe V6-3.2L (CBRA) (2008)
‹› With vulcanized gasket
‹› Always replace
4
Haldex Clutch Control Valve (N373)
‹› Is calibrated with All-Wheel Drive Control Module (J492)
‹› Always replace together with control module => [ (Item 1) ]
5
Oil seal
‹› Diameter 12 mm
‹› For Haldex Clutch Control Valve (N373)
‹› Coat with High Performance Haldex Clutch Oil and insert
‹› Always replace
6
Oil seal
‹› Diameter 11 mm
‹› For Haldex Clutch Control Valve (N373)
‹› Coat with High Performance Haldex Clutch Oil and insert
‹› Always replace
7
Oil seal
‹› In Haldex clutch housing
‹› Coat with High Performance Haldex Clutch Oil and insert
‹› Always replace
8
Oil seal
‹› For pressure sensor
‹› Coat with High Performance Haldex Clutch Oil and insert
‹› Always replace
9
Oil Pressure/Temperature Sensor (G437)
‹› Can be reused when replacing control module
‹› Removing and installing, refer to => [ Rear Final Drive 02D and 0AV, AWD Control Module ] See: Rear Final Drive 02D and 0AV, AWD
Control Module
10
Plate spring
‹› In installation position, marking - arrow - must be located at top and face toward pressure sensor => [ Plate Spring Location ]
Plate Spring Location