TT Quattro Coupe V6-3.2L (CBRA) (2008)
/Page-2246002.png)
-
Remove bolts - 3 - (Qty.4).
NOTE: To provide a better overview, upholstery is shown without cover in illustration.
-
Remove bracket - 1 - upward from seat pan - 2 -.
Installing
Installation is reverse of removal. Observe the following when doing so:
CAUTION:
-
Observe safety precautions for work on airbags Airbag system, general safety precautions.
-
Before handling airbag units (e.g. disconnecting electrical connector), the person handling it must "electrostatically discharge". This can
be done by touching door striker, for example.
NOTE: Ensure that electrical connections are pushed in as far as stop and engage with a click.
-
Switch on ignition.
CAUTION: Ignition must be on when connecting battery. If pyrotechnic components (e.g. airbag, belt tensioner) are not repaired
correctly, they may deploy unintentionally after connecting battery. There must not be anyone inside the vehicle when connecting the
battery.
-
Connect battery ground wire with ignition switched on.
-
If Airbag Malfunction Indicator Lamp (MIL) K75 indicates a fault after installation, DTC memory must be checked, deleted and checked again
Vehicle Diagnosis, Testing and Information System VAS 5051 B.
