TT Quattro Coupe V6-3.2L (CBRA) (2008)
‹› Rear side cover with adhesive film
‹› With top tether
3
Bolt
‹› Tightening specification, refer to => [ Backrest Frame and Panel Assembly Overview ] See: Body and Frame/Seats/Service and
Repair/Removal and Replacement/Rear Seats, Coupe Only
‹› Quantity: 16
4
Backrest Frame
‹› To replace backrest frame, remove left and right backrest shell
‹› Assembly overview, refer to => [ Backrest Frame and Panel Assembly Overview ] See: Body and Frame/Seats/Service and Repair/Removal
and Replacement/Rear Seats, Coupe Only
‹› Removing and Installing, refer to => [ Backrest Frame ] See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Rear Seats,
Coupe Only
‹› Optional equipment:
‹› With child seat anchor (LATCH)
‹› Without child seat anchor
5
Double Sided Adhesive Tape
‹› Attach to front side and upper edge of backrest shell
LATCH Child Seat Anchorage, Removing and Installing
The child seat anchor (LATCH) is welded to the backrest frame. To remove and install the child seat anchor, backrest frame must be removed and
replaced.
Child seat anchor (LATCH), removing and installing, refer to => [ Backrest Frame and Panel Assembly Overview ] See: Body and
Frame/Seats/Service and Repair/Removal and Replacement/Rear Seats, Coupe Only