TT Quattro Coupe V6-3.2L (CBRA) (2008)
/Page-2271002.png)
To install, perform the steps used in removal in reverse order. Observe the following when doing so:
-
Make sure the anti-twist mechanism - arrow A - on bottom side of seat belt latch - 1 - is insert in opening - arrow B - on center bearing - 2 -.
-
Pull the tab on the cover under the axle for the seat belts and tilt it upward - 1 -.
-
Insert and the tab into the slot in the cover and lock it - 2 -, where applicable.
Tightening specifications, refer to => [ Rear Belt Latch Assembly Overview ] See: Service and Repair.
