TT Quattro Coupe V6-3.2L (CBRA) (2008)
/Page-1616001.png)
Wiring Harness: Procedures
Wire, 0.35 mm and Larger With Individual Crimp Connector, Repairing
Wire, 0.35 mm And Larger With Individual Crimp Connector, Repairing
Procedure
-
Free up the wire to be repaired approximately 20 cm on both sides of the repair point.
CAUTION:
Risk of damaging the electrical wires.
-
Free up wrapped wiring harnesses carefully.
-
If necessary, removing the wiring harness wrapping using a knife.
-
Cut out the damaged wire section using wire stripper VAS 1978/3.
NOTE: If, by cutting out the damaged wire section, both ends of the vehicle-specific single wire are too short for a repair using a single crimp
connector, insert a repair wire section of matching length with two crimp connections.
-
Adjust the sliding stop in the Wire Stripper VAS 1978/3 pliers jaws to 6 to 7 mm for the wire to be stripped.
-
Insert wire end from front up to stop into jaws of pliers and squeeze the pliers completely.
-
Open pliers again and remove the stripped wire end.
-
For the repair, use a suitable crimp connector form the Wiring Harness Repair Set VAS 1978A.
-
Use the Crimping Pliers (Base Tool) VAS 1978/1-2 to press the crimp connector.
The following exchangeable heads are available for the Crimping Pliers (Base Tool) VAS 1978/1-2 :
