TT Quattro Coupe V6-3.2L (CBRA) (2008)
/Page-1884006.png)
-
Peen the adjustment screw 6 times - arrows - using a punch.
Punch points must be applied 2 graduation lines next to the drill out punch points.
-
Mark one graduation line of adjustment screw on the steering gear housing - 1 -.
-
Remove the adjustment screw 5.5 graduation lines toward left - 2 -.
While doing this, a loosening torque of at least 15 Nm must be obtained.
If loosening torque is not obtained:
