TT Quattro Coupe V6-3.2L (CBRA) (2008)
‹› Replace
‹› Pull onto line connection
‹› Install with brake fluid
4
Retaining clip
5
Bleeder screw
‹› 4.5 Nm
6
Protective cap
7
Retaining clip
8
Hose/line assembly
‹› To master cylinder
‹› On bleeder, disconnecting and reconnecting => [ Hose/line assembly to bleeder, removing and
installing ]
‹› Removing and installing => [ Hose/Line Assembly, Removing ] See: Clutch Hydraulic System/Hydraulic Hose/Service and Repair
9
O-Ring
‹› Replace
‹› Pull onto line connection
‹› Install with brake fluid
10
Bleeder
‹› Removing and installing => [ Bleeder at slave cylinder, removing and installing ]
11
Seal
‹› For input shaft
‹› Removing and installing => [ Input Shaft Seal, Replacing ] See: Manual Transmission/Transaxle/Seals and Gaskets/Service and Repair/02QA
Transmission/Input Shaft Seal, Replacing
Hose/line assembly to bleeder, removing and installing
-
To remove, release securing clip - 2 - with a screwdriver and pull off hose/line assembly - 4 - at bleeder - 1 -.