TT Quattro Coupe V6-3.2L (CBRA) (2008)
/Page-1272001.png)
Drive/Propeller Shaft: Removal and Replacement
Driveshaft with Inseparable Center Support, from 05.2007, Removing
Driveshaft with Inseparable Center Support, from 05.2007, Removing
Special tools, testers and auxiliary items required
‹› Torque Wrench (V.A.G 1332)
‹› Engine/Transmission Jack (V.A.G 1383 A)
Removing
‹› Perform work on driveshaft on a two-column lift if possible.
‹› Before removing, mark the positions of all parts in relation to each other. Re-install in the same position otherwise imbalance will be excessive, the
bearings could be damaged causing rumbling noises.
‹› Do not kink driveshaft, only store and move when fully extended.
‹› Do not allow driveshaft to hang down when removing, always support.
‹› Always remove or install driveshaft horizontally on drive flange.
Audi A3
-
Remove the noise insulation - arrows -.
Audi TT
-
Remove center noise insulation fastening parts - 1 to 4 -.
