TT Quattro Coupe V6-3.2L (CBRA) (2008)
/Page-1252004.png)
Installed location of spring washer and thrust washer on outer joint
Outer CV joint, installing
-
Before installing CV joint or triple roller star, splines -A- must be lightly coated with grease used in joint.
-
Install old drive shaft bolt in joint as shown in the illustration.
-
Drive joint onto shaft with plastic hammer until circlip engages.
Inner constant velocity joint, disassembling and assembling
Removing securing ring using Circlip Pliers VW 161 A
