TT Quattro Coupe V6-3.2L (CBRA) (2008)
/Page-1252006.png)
-
Before installing CV joint or triple roller star, splines -A- must be lightly coated with grease used in joint.
Note:
^
Chamfer on inner diameter of ball hub (splines) must face contact shoulder of drive axle.
-
Install circlip
-
Apply sealant - hatched surface - to clean surface on inner side of protective joint boot cap. Sealant bead: unbroken, dia. 2 to 3 mm. Skirt area
around inner holes -arrow-.
-
Use sealant D 454 300 A2 for this
-
Slide joint protective boot onto drive axle.
Drive axle, protective joint boot and cap contact surfaces must be free of grease.
Make sure you do not damage sealant bead.
