TT Quattro Coupe V6-3.2L (CBRA) (2008)
/Page-1311005.png)
-
Cut cable ties - 1 - and press electrical wires to side.
-
Unclip wiring guide.
-
Remove bolts - 1 - and remove transmission mount - A -.
Installing
‹› Tightening torques => [ Subframe Mount Assembly Overview ] See: Subframe Mount Assembly Overview.
Installation is in reverse order of removal, paying attention to the following:
-
Install transmission mount - A - on long member.
-
Raise transmission with engine support bridge spindle until transmission plate - 1 - touches transmission mount support arm - 2 -.
