TT Quattro Coupe V6-3.2L (CBRA) (2008)
Transmission Speed Sensor: Service and Repair
Transmission Input Speed Sensor and Clutch Oil Temperature Sensor
Removing
CAUTION!
Risk of transmission damage.
‹› Do not run engine or tow vehicle with oil pan removed or without transmission fluid.
‹› Observe general repair notes. Refer to => [ Repair Information ] See: Automatic Transmission/Transaxle/Service and Repair/Procedures/02EA
Transmission/Repair Information.
‹› Observe cleanliness rules when working on transmissions. Refer to => [ Clean Working Conditions ] See: Automatic
Transmission/Transaxle/Service Precautions/02EA Transmission/Clean Working Conditions.
-
Remove oil pan. Refer to => [ Oil Pan ] See: Automatic Transmission/Transaxle/Fluid Pan/Service and Repair/Oil Pan.
-
Remove DSG mechatronic. Refer to => [ DSG Mechatronic ] See: Automatic Transmission/Transaxle/Service and Repair/Removal and
Replacement/02EA Transmission/DSG Mechatronic.
-
Remove bolt - B -.
-
Remove transmission input speed sensor and clutch oil temperature sensor - A - together with wire - C - from transmission.
Installing
‹› Tightening Specifications, refer to => [ Oil Pan, Mechatronic and Transmission Fluid Pump Assembly Overview ] See: Automatic
Transmission/Transaxle/Fluid Pan/Service and Repair/Oil Pan, Mechatronic and Transmission Fluid Pump Assembly Overview, and to => [
Transmission Input Speed Sensor and Clutch Oil Temperature Sensor ] See: Automatic Transmission/Transaxle/Fluid Pan/Service and Repair/Oil
Pan, Mechatronic and Transmission Fluid Pump Assembly Overview
Install in reverse order, noting the following:
-
Coat transmission input speed sensor and clutch oil temperature sensor with gear oil.
-
Insert transmission input speed sensor and clutch oil temperature sensor in side opening on transmission and tighten. Refer to => [ Transmission