TT Quattro Roadster L4-1.8L Turbo (AMU) (2002)
Alignment: Service and Repair
Toe at Front Wheels, Adjusting
Toe at front wheels, adjusting
-
Counterhold tie rod ball joint -A- with a 24 mm wrench when loosening and tightening lock nut -B-.
-
Loosen lock nut -B-.
-
Adjust toe at left and right-hand wheels by turning hex flats -C-.
Make sure that boots are not twisted after turning tie rods.
Twisted rubber boots wear out quickly.
-
Tighten lock nut -B- to 50 Nm and check toe-in setting again.
The setting may change slightly after tightening lock nut -B-.
The adjustment is correct if the measured toe value is still inside the tolerance.