TT Quattro Roadster L4-1.8L Turbo (AMU) (2002)
-
Remove center noise insulation (arrows).
-
Disconnect connector for Secondary Air Injection (AIR) pump motor -1- (V101).
-
Connect VAG1527B voltage tester between terminals 1 and 2
-
Initiate output Diagnostic Test Mode (DTM) and activate Secondary Air Injection (AIR) pump relay -J299-. See: Computers and Control
Systems/Testing and Inspection/Scan Tool Testing and Procedures/Scan Tool Testing/With Manufacturer's Scan Tool
-
LED must blink.
If LED does not blink:
-
Perform the following tests marked with dots:
-
Check wire connection from connector at Secondary Air Injection (AIR) pump motor -V101- to Secondary Air Injection (AIR) pump relay
-J299- (in relay carrier below cover, left at bulkhead) for open circuit:
IMPORTANT: Check wire connection from connector at Secondary Air Injection (AIR) pump motor -V101- to Ground (GND) point in engine
compartment, left, for open circuit:
If no malfunctions are detected:
-
Replace Secondary Air Injection (AIR) pump motor -V101-.