TT Quattro Roadster L4-1.8L Turbo (AMU) (2002)
Test requirement:
-
Battery voltage at least 11 V
Function test of Fuel Pump (FP) relay
-
Remove driver-side storage compartment.
-
Connect VAS5051 tester or VAG1551 scan tool and select the control module for engine electronics using "address word" 01. See: Computers
and Control Systems/Testing and Inspection/Scan Tool Testing and Procedures/Scan Tool Testing/Scan Tool Connecting and Initial
Checks/Connecting VAS 5051/VAG1551 Scan Tool
Ignition must remain switched on for this.
-
Initiate output Diagnostic Test Mode and activate Evaporative Emission (EVAP) canister purge regulator valve -N80- (Tank Ventilation Valve).
See: Computers and Control Systems/Testing and Inspection/Scan Tool Testing and Procedures/Scan Tool Testing/With Manufacturer's Scan Tool
-
Fuel Pump (FP) relay (at position 4 of micro-central electronics in driver's footwell, left) must trigger and Fuel Pump (FP) must run.
If relay does not trigger:
-
Checking activation of Fuel Pump (FP) relay
If Fuel Pump (FP) does not run:
-
Check voltage supply for Fuel Pump (FP) and components (via Fuel Pump -FP- relay).
Check activation of Fuel Pump (FP) relay.
-
Switch ignition off.
-
Connect VAG1598/31 test box at wiring harness to ECM, do not connect ECM. See: Computers and Control Systems/Testing and Inspection/Scan
Tool Testing and Procedures/Scan Tool Testing/Scan Tool Connecting and Initial Checks/Wiring and Component Testing Using VAG1598/31
Test Box
-
Connect socket 65 and socket 2 of test box to each other using adapter cable from VAG1594 connector test kit.
-
Switch ignition on.