TT Quattro Roadster L4-1.8L Turbo (AMU) (2002)
-
Using crimp connectors on the ends of the wires, crimp on both sides with crimping pliers.
-
Do not crimp the insulation on the wires
-
Make sure that the correct crimping slot is used (red color code for 0.5 sq.mm wires)
-
After crimping the connector, seal it by shrinking with a hot air blower.
-
Heat the crimp connector from the center outward until it is completely sealed and the adhesive comes out.
-
Set the hot air blower to the correct temperature (refer to operating manual).
-
When heating the connector, take care not to damage any other wiring, plastic parts or insulating material with the hot nozzle.
-
If the wire was originally taped, wrap it again with yellow insulating tape. If necessary, secure the wiring with new cable ties.