TT Quattro Roadster L4-1.8L Turbo (AMU) (2002)
/Page-2149001.png)
Seals and Gaskets: Service and Repair
O - Ring For Rear Axle Cover (Final Drive Installed).
O- ring for rear axle cover (final drive installed), replacing
Removing
-
Drain gear oil.
-
Remove left or right drive flange.
-
Remove right - hand cover or left - hand cover, when doing this screw bolts -A - in evenly so that the cover does not cant.
-
Remove right - hand cover together with differential.
-
Then remove the O - ring - A -.
Installing
Installation is carried out in the reverse sequence, when doing this note the following:
-
Lubricate O-ring - A - with gear oil and install.
-
Top up oil to lower edge of filler hole.
-
Checking gear oil in rear final drive.
Tightening torque
Cover to rear axle housing tightening torque: ......................................................................................................................................................... 25 Nm
