TT Quattro Roadster V6-3.2L (BHE) (2005)
^
Observe locating point
^
Lubricating groove faces crankshaft
6 - Bearing cap
^
Bearing cap 1: belt pulley side
^
Bearing cap 5 with notches for thrust washers
^
Retaining tabs of bearing shells and cylinder block/bearing caps must lie above one another
7 - 30 Nm + 180 degrees (1/2 turn) further
^
Replace
8 - Bearing shell
^
For bearing cap without bore
^
Do not interchange used bearings (mark)
^
Replacement parts are only color coded "yellow"
9 - Thrust washer
^
For bearing 5
^
Observe locating point
^
Lubricating groove faces crankshaft
10 - Sensor wheel
^
For Engine speed sensor -G28-
^
Sensor wheel must be replaced every time bolts are loosened
11 - 10 Nm + 90 degrees (1/4 turn) further
^
Replace
^
Sensor wheel must be replaced every time bolts are loosened
Removing and installing sensor wheel
The sensor wheel and securing bolts must be replaced every time the bolts are loosened.
^
Contact surface of crankshaft/sensor wheel must be free of oil and grease.
-
Thinly coat contact surface of crankshaft/sensor wheel with locking fluid.
Installed location
^
"VR6" marking -2- must be positioned at bore of bolt -3- that goes into crankshaft crankpin (contour of crankshaft is shown by dashed line -1-)
^
Gap (arrow) in ring gear lies across from designation
^
Second "VR6" marking -4- may be ignored
-
Tighten new bolts only finger-tight.
-
Tighten bolt -1-.
-
Tighten bolt -2-.