TT Quattro Roadster V6-3.2L (BHE) (2005)
/Page-2640001.png)
Center Mounted Brake Lamp: Service and Repair
High Mount Brake Light - Roadster, Removing And Installing
Removing
CAUTION:
Before beginning repairs on the electrical system:
-
Switch off all electrical consumers.
-
Switch ignition off and remove ignition key.
NOTE:
-
Do not operate brake pedal.
-
In the event of a malfunctioning LED, the complete high-mount brake light assembly must be replaced.
-
Open rear lid.
-
Depress locating tabs -1- using a flat screwdriver and remove luggage compartment light -2- from trim.
NOTE: Electrical connection -3- remains connected.
-
Pull luggage compartment light wiring harness out from opening in trim and disconnect electrical connection -arrow-.
-
Close rear lid.
-
Carefully unclip cover for high mount brake light from the front (leading) edge towards the rear of the vehicle as shown -arrows-.
CAUTION: DO NOT unclip cover from rear edge towards the front of the vehicle. Damage to cover and/or light assembly will result.
