TT Quattro Roadster V6-3.2L (BHE) (2005)
/Page-1954003.png)
-
Detach tie rods from steering arms using puller Kukko 129/0.
-
Place tray underneath vehicle to catch hydraulic fluid.
-
Disconnect expansion hose - 2 - from steering gear and seal off with a plastic bag and adhesive tape.
-
Seal off threaded hole at steering gear (e.g. with plastic screw plug).
-
Return line - 1 - can be disconnected after lowering subframe.
-
Unbolt pendulum support on transmission side.
-
Install engine/transmission jack V.A.G1383A with attachment -1359/2-.
-
Loosen bolts - 1 -.
-
Remove subframe bolts - 2 - and -3 -.
-
If necessary, remove hex nut for retaining clip on stabilizer bar clamp (left-side). Tightening torque: 22 Nm
