TT Quattro Roadster V6-3.2L (BHE) (2005)
11 -
Wheel hub with rotor for wheel speed sensor
Pay attention notes and table
^
Rotor is welded to wheel hub
12 -
Backing plate
13 -
Snap ring
^
Check for proper seating
14 -
Wheel bearing
Before pressing in wheel bearing, coat entire inner surface of bore in wheel bearing housing with Molypaste
15 -
Self-locking nut
^
Tightening torque: 75 Nm
^
TT VR6 Roadster: 150 Nm
^
Always replace if removed
16 -
Ball joint
^
Mark installation position; if control arm is replaced, place in center of elongated hole and check toe setting/camber
17 -
Brake carrier
18 -
Brake caliper
^
Do not disconnect brake hose when working on front suspension
^
Tie in position with wire or similar
19 -
Guide pins, 25 Nm
20 -
Protective cap
21 -
Ribbed bolt, 125 Nm
^
Clean ribbing on underside of bolt head
^
Brake line must not be twisted or kinked
22 -
Self-locking nut
^
60 Nm plus and additional 90°1/4 turn
^
Always replace if removed
23 -
Wheel bearing housing
Before pressing in wheel bearing, coat entire inner surface of bore in wheel bearing housing with Molypaste
24 -
Drive axle
Pay attention to notes and table
^
Pressing drive axle out of wheel hub; pressing in, Drive axles
Disconnecting suspension strut from wheel bearing housing
-
Insert special tool - 3424 - as shown and force wheel bearing housing apart.