audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

Gear Oil Level, Checking and Topping Up|Page 3543 > < Gear Oil Level, Checking and Topping Up
Page 1
background image

Fluid - A/T: Removal and Replacement
Gear Oil Level, Checking

Gear oil level, checking, 02E, 6 Speed Direct Shift A/T, AWD

CAUTION!
^

The engine must not be started if significant oil loss has occurred (e.g. during repairs) and there is little or no oil left in the transmission.

^

If necessary, perform a pre-filling of gear oil for the direct shift transmission.

^

Only the gear oil for the direct shift transmission (available as a replacement part) may be used for the direct shift transmission 02E.
Other oils cause faults and/or failure of the transmission.

^

Gear oil part number. 

^

Transmission must not be in emergency running (backup) mode.

^

Vehicle must be level (horizontal).

^

Selector lever at position "P".

^

Engine idling.

^

Air conditioning and heating system switched off.

^

Vehicle diagnostic, testing and information system VAS 5051 connected; vehicle self-diagnosis and vehicle system "02 - Gearbox electronics"
selected.

^

The gear oil temperature at the beginning of the test must not be higher than 30°C. If necessary, first allow the transmission to cool down.

Note:  
^

The gear oil temperature is taken from the reading on the vehicle diagnostic, testing and information system VAS 5051.

^

The gear oil level will vary according to the gear oil temperature.

^

If the gear oil level is checked when the gear oil temperature is too low, this will result in overfilling.

^

If the gear oil level is checked when the gear oil temperature is too high, this will result in underfilling.

^

Both overfilling and underfilling have a detrimental effect on the functioning of the transmission.

Reading gear oil temperature 

Indicated on vehicle diagnostic, testing and information system VAS 5051:
-

From list - 1 - select diagnostic function "08 - Read measured value block".

Indicated on vehicle diagnostic, testing and information system VAS 5051:
1 - 

Enter display group (max. input value = 255).

-

Use keypad - 2 - to enter "19" for "Display group number 19" and confirm by touching Q key.

Gear Oil Level, Checking and Topping Up|Page 3543 > < Gear Oil Level, Checking and Topping Up