TT Quattro Roadster V6-3.2L (BHE) (2005)
Example: 01J-927-156FE - 3011 can be flashed, after flashing the data version changes to 01J-927-156FE - 3031
Old identification
New identification
01J-927-156_FE 3011
01J-927-156_FE 3031
01J-927-156_CS 3011
01J-927-156_CS 3031
01J-927-156_DB 3011
01J-927-156_DB 3031
01J-927-156_FD 3011
01J-927-156_FD 3031
01J-927-156_CJ 3011
01J-927-156_CJ 3031
01J-9271-56_DD 3011
01J-927-156_DD 3031
01J-927-156_CL 3011
01J-927-156_CL 3031
Fault memory entries in the control units are deleted when the flash procedure is completed.
With the VAS 5051/5052 still connected, the transmission control module (TCM) must be adjusted as follows:
1. Warm up the vehicle. The gear oil temperature must be at least 60 degrees C (measured value block 10 or 11, display field 3).
2. Drive in part load in driving mode D. After about 10 m, stop the vehicle with the brake pedal. Leave in driving mode D and press the brake pedal
in stationary for about 10 seconds.
3. Drive in part load in driving mode R. After about 10 m, stop the vehicle with the brake pedal. Leave in driving mode R and press the brake pedal
in stationary for about 10 seconds.
4. Repeat the above procedure, alternating between driving mode D and R five times. Then the adjustment is completed.
5. The display in measured value block 10/11 display field 2 can be ignored.
Warranty
Required Parts and Tools
All part and service references provided in this TSB are subject to change and/or removal. Always check with your Parts Dept. and service manuals for
the latest information.