TT Quattro Roadster V6-3.2L (BHE) (2005)
Seals and Gaskets: Service and Repair
Oil Seal For Flange Shaft (Left Side), Replacing
Oil seal for flange shaft (left side), replacing, 02E, 6 Speed Direct Shift A/T, AWD
Special tools, testers and auxiliary items required
^
Drip tray V.A.G 1306
^
Thrust piece 3305
Removing
It is possible to replace the oil seals without removing the transmission.
Note:
^
Read rules for cleanliness when working on the automatic transmission.
^
General repair instructions.
-
Remove left axle shaft.
-
Place drip tray V.A.G 1306 under transmission.
-
Remove countersunk bolt for flange shaft; use a drift to prevent turning. (Bolt must be replaced).
-
Pull out flange shaft and spring.
-
Pry out oil seal with assembly lever.
Installing
Perform installation in reverse sequence of removal. Note the following: