Adjusting Shift Interlock Cable: Component Information for 2005 TT Quattro Roadster
/Page-1159001.png)
Shift Interlock Cable: Adjustments
Locking cable, adjusting, 02E, 6 Speed Direct Shift A/T, AWD
Special tools, testers and auxiliary items required
^
Locking cable adjustment gauge 3352 A
CAUTION! To adjust the locking cable always proceed as described below.
Requirements
^
Locking cable is in installed position
^
Rear center console has been removed.
^
Selector lever is in position "P"
^
Ignition key is in removal position.
Adjusting
^
Steering column in lowest/rear most position.
CAUTION! Follow steps required when disconnecting battery.
Note: The battery is located in the rear compartment, in the spare wheel well.
-
Disconnect ground strap on battery (in rear compartment) with ignition switched off.
-
Remove selector lever handle.
-
Remove rear center console.
-
Remove selector mechanism cover.
-
Loosen bolt at support bracket.
-
Fit locking cable adjustment gauge 3352 A between locking lever - 1 - and locking cable eye - 2 -.
-
To compensate for play, pull support bracket up to limit stop in direction of arrow to insert gauge.
-
Tighten bolt - B - at support bracket (10 Nm).
-
Remove adjustment gauge.
-
Check operation of ignition key withdrawal lock.
-
Install selector mechanism cover.
-
Install rear center console.
-
Install selector lever handle.
-
Connect ground strap to battery.
-
Follow steps required after connecting battery.
