TT Quattro Roadster V6-3.2L (BHE) (2005)
/Page-1211002.png)
^
Drive off with drift before pressing off constant velocity (CV) joint
^
Check for damage
10 -
Plate spring
^
Splines on interior diameter
^
Installation position: Larger diameter makes contact on CV joint
11 -
Gasket
^
Replace, remove protective foil and adhere in joint
12 -
CV joint
^
Pressing off
^
Pressing on
^
Grease specification: Press 25 g G-6.3 grease on each side (total 50 g) into joint. When replacing CV boot add more grease to joint, if necessary.
13 -
Circlip
^
Replace
14 -
Bolt, 45 Nm
15 -
Washer
^
Always replace
16 -
Flange
^
Pulling off
^
Pulling on
17 -
Center bearing
^
Pulling off
^
Installed location
^
Driving on
18 -
Bolt, 25 Nm
19 -
Rear drive shaft tube
^
Do not damage centering sleeve and seal when removing and installing in center of flange
20 -
Collar bolt with 12-point nut, 60 Nm
^
Change: As of 06.99, new securing bolts with inner 12-point heads used.
^
Two of new securing bolts can be installed with a balancing washer in place of a mounting washer.
21 -
Flexible disc with vibration dampener
^
Installed location
22 -
Collar bolt with 6 - or 12-point nut, 60 Nm
^
Change: Longer mounting bolts from 01.03.
^
Two of the projecting bolt ends can be covered with one nut each and possibly also one or more washers.
23 -
Rear final drive
