TT Roadster L4-1.8L Turbo (AWP) (2003)
Speaker: Service and Repair
Speaker Assembly Carrier (Vehicles Without CD-Changer), Removing and Installing
Speaker Assembly Carrier (vehicles Without CD-changer), Removing And Installing
1
-
Speaker assembly carrier
-
Loosen rear panel cover (without removing the mounting point for the outer seat belt floor assembly) and insert a wedge between rear
panel cover and crossmember for roll bar
-
Remove rear panel side trim
-
Remove clips - 6 - on vehicles without navigation.
-
Remove right storage compartment on vehicles with navigation
-
Disconnect harness connector to actuator - 7 - for center storage compartment.
-
Disconnect cable harness from loudspeaker assembly carrier - 1 -.
-
Remove clip - 11 -.
-
Remove bolt - 10 - (1x).
-
Press floor mat downward and remove nuts - 2 - (2x).
-
Remove bolts - 3 - (2x).
-
Remove bolts - 5 - (2x).
-
Remove nut - 4 - (2x).
-
Pull speaker assembly carrier - 1 - with compartment - 9 - forward and disconnect harness connector to loudspeaker.
2
-
Nut (2x)
-
Tightening torque 8 Nm
3
-
Bolts (2x)
-
Tightening torque 8 Nm
4
-
Nut (2x)
-
Tightening torque 8 Nm
5
-
Bolts (2x)
-
Tightening torque 8 Nm
6
-
Clip
7
-
Lock actuator for center flap
8
-
Right storage compartment
9
-
Left storage compartment
10
-
Bolt (1x)