TT Roadster L4-1.8L Turbo (AWP) (2003)
-
Place suitable container under connection -B- and carefully expel coolant from heater core (using compressed air) through connection - A-.
-
Remove expansion valve.
-
Seal off refrigerant pipes and open connections -A- and -B- on evaporator.
-
Remove hex nuts with washers -C-, tightening torque 15 Nm (11 ft lb).
NOTE: Washers for hex nuts should be fitted with seals.
-
Fold back pre-punched flaps -A- on insulation mat and remove hex nuts and washers -B- underneath, tightening torque 15 Nm (11 ft lb).
-
Remove glove box.
-
Remove storage compartment on driver's side, dash panel center section and instrument panel.
-
Remove center console (complete).
-
Remove footwell vent.
-
Remove air duct -A- (leading to defroster vent).
-
Remove front passenger's airbag unit (complete) together with lefthand bracket for instrument panel cross member.
-
Disconnect Ground (GND) connection between heating and A/C unit and ground connection at bottom of right A-pillar.
-
Cover all exposed connectors and the A/C air ducts (protection from drilling remains).