TT Roadster L4-1.8L Turbo (AWP) (2003)
Headlamp Bulb: Service and Repair
Hid Bulb, Replacing
HID Bulb, Replacing
NOTE: Left or right engine compartment trim must be removed prior to access to rear of headlight housing.
Removing
WARNING:
-
HIGH VOLTAGE!
-
Always disconnect battery Ground (GND) strap prior to servicing any parts of the HID lamp system marked with the yellow "HIGH
VOLTAGE!" symbol.
-
After disconnecting battery, briefly turn headlights on and off in order discharge any residual voltage.
-
Remove cover -13- from headlight housing -1-.
-
Rotate electrical harness connector at HID bulb -2- counter-clockwise and remove.
-
Rotate securing ring -4- for HID bulb -3- counter-clockwise and remove.
-
Remove HID bulb -3- from housing.
Installing
CAUTION: Do not touch glass portion of bulb with bare hands. Even the smallest amount of moisture and/or contaminants from fingers that
evaporates on the bulb during operation can cause the glass to cloud over.
-
Insert new bulb in bulb holder.
-
Secure HID bulb using securing ring -4- (rotate clockwise).
-
Connect electrical harness connector -2- at HID bulb and rotate clockwise to secure.
-
Close housing cover -13-.