TT Roadster L4-1.8L Turbo (AWP) (2003)
/Page-4988001.png)
Headlamp Alignment Control Module: Service and Repair
Headlight Range Control Module -J431-, Removing and Installing - Roadster
Headlight Range Control Module -J431- Roadster, Removing and Installing - Roadster
Removing
CAUTION!
Before Beginning repairs on the electrical system:
- Switch off all electrical consumers.
- Switch ignition off and remove ignition key.
1. Remove rear side panel trim, please refer to Body and Frame/ Interior Moulding/Trim/ Trim Panel/ Service and Repair/ See: Body and Frame/Interior
Moulding / Trim/Trim Panel/Service and Repair
2. Release nuts - arrows -.
3. Remove module -1-.
4. Disconnect electrical connection -1-.
Installing
1. Install in reverse of removal, noting the following:
-
OBD function - "Basic setting" must be performed on -J431- when replacing - VAS 5051/5052 in operating mode "Guided Fault Finding".
Tightening Torques
Component ..................................................................................................................................................................................................................... Nm
Control Module to Body .................................................................................................................................................................................................. 2.5
