audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ATF Level, Checking|Page 2565 > < Fluid - A/T|Capacity Specifications|Page 2561
Page 1
background image

Fluid - A/T: Removal and Replacement
ATF Level, Checking

ATF level, checking, 09G, 6 Speed A/T 

Special tools and equipment 

^

Vehicle diagnostic, testing and information system VAS 5051

^

Drip tray V.A.G 1306

^

Filler system V.A.G 1924

^

Protective goggles

Requirements 

^

Transmission not in emergency running mode.

^

Vehicle must be level (horizontal)

^

Selector lever at position "P", engine idling.

^

Air conditioner and heating system must be switched off.

^

Vehicle diagnostic, testing and information system VAS 5051 connected, "Vehicle self-diagnosis and vehicle system "02 - transmission
electronics" selected.

^

The ATF temperature at the beginning of the test must not be higher than 30°C. If necessary, first allow the transmission to cool. 

Note:  
^

The ATF temperature is read from the vehicle diagnostic, testing and information system VAS 5051.

^

The ATF level will vary according to the temperature of the ATF.

^

If the ATF level is checked when the ATF temperature is too low, this will result in overfilling.

^

If the level is checked when the ATF temperature is too high, this will result in underfilling.

^

Both overfilling and underfilling have a detrimental effect on the functioning of the transmission.

^

Only the ATF available as a replacement part may be used in the automatic transmission 09G. Other oils cause faults and/or breakdown of the
transmission.

^

The ATF temperature is read from the vehicle diagnostic, testing and information system VAS 5051. 

Reading ATF temperature 

ATF Level, Checking|Page 2565 > < Fluid - A/T|Capacity Specifications|Page 2561