TT Roadster L4-1.8L Turbo (AWP) (2003)
-
Disconnect connector -1- from Intake Air Temperature (IAT) Sensor - G42- -2-.
-
Bridge terminals 1 + 2 of connector using the respective adapter cables while observing the indication on display.
If indication jumps to approx. 143 degree C:
-
End diagnosis and switch ignition off.
-
Replace Intake Air Temperature (IAT) Sensor -G42-.
-
Erase DTC memory of Engine Control Module (ECM), Diagnostic mode 4: Reset/erase diagnostic data. See: Testing and Inspection/Scan Tool
Testing and Procedures/Scan Tool Testing/With Generic Scan Tool/Diagnostic Mode 4: Reset/Erase Diagnostic Data
-
Generate readiness code. See: Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes/Audi Drive Cycle/Readiness Code/With
Generic Scan Tool/Readiness Code, Generating
If indication remains at approx. -40 degree C:
-
End diagnosis and switch ignition off.
-
Check wires according to wiring diagram.
Continuation of test if indication is approx. 143 degree C:
-
Disconnect connector -1- from Intake Air Temperature (IAT) Sensor - G42- -2-.
If indication jumps to approx. -40 degree C:
-
End diagnosis and switch ignition off.
-
Replace Intake Air Temperature (IAT) Sensor -G42-.
-
Erase DTC memory of Engine Control Module (ECM), Diagnostic mode 4: Reset/erase diagnostic data. See: Testing and Inspection/Scan Tool
Testing and Procedures/Scan Tool Testing/With Generic Scan Tool/Diagnostic Mode 4: Reset/Erase Diagnostic Data
-
Generate readiness code. See: Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes/Audi Drive Cycle/Readiness Code/With
Generic Scan Tool/Readiness Code, Generating
If indication remains at approx. 143 degree C:
-
End diagnosis and switch ignition off.
-
Check wires according to wiring diagram.
Checking wiring
-
Connect test box to control module wiring harness, connect test box for wiring test. See: Testing and Inspection/Reading and Clearing Diagnostic
Trouble Codes/Scan Tool Connecting/With Generic Scan Tool/Test Box, Connecting For Wiring Test