Audi Workshop Service and Repair Manuals

Wheel Speed Sensor: Service and Repair
Front Wheel Drive

Speed sensor, removing and installing

Removing

-

Raise vehicle.

-

Disconnect harness connector -1- from wheel speed sensor wire and wheel speed sensor.

-

Remove bolt -2- from stub axle.

-

Pull ABS wheel speed sensor out of stub axle.

Installing

Install in reverse sequence; note the following points:

-

Before inserting wheel speed sensor, clean inner surface of bore hole and coat sensor completely with securing grease G 000 650

Tightening torque
Speed sensor to stub axle ..........................................................................................................................................................................................  8 Nm